How can reload information for startup and system replication be collected? The following parameter is used to control the collection of reload information:
Parameter Name - tablepreload_write_interval
Default Value - 3600 (HANA Revision 69 and below)
Default Value - 86400 (HANA Revision 70 and above)
About Parameter -
This parameter defines the frequency of collecting table load information for reloads during startup and on the secondary system replication side.Collection of the data is disabled by setting the value to 0.
How to Set Parameter - global.ini -> [persistence] -> tablepreload_write_interval
Additional Command - In exceptional cases you can manually execute the following hdbcons command in order to collect the current load state.
tablepreload writeinfo
Reference From - SAP Note 1889081 for more information.
Parameter Name - tablepreload_write_interval
Default Value - 3600 (HANA Revision 69 and below)
Default Value - 86400 (HANA Revision 70 and above)
About Parameter -
This parameter defines the frequency of collecting table load information for reloads during startup and on the secondary system replication side.Collection of the data is disabled by setting the value to 0.
How to Set Parameter - global.ini -> [persistence] -> tablepreload_write_interval
Additional Command - In exceptional cases you can manually execute the following hdbcons command in order to collect the current load state.
tablepreload writeinfo
Reference From - SAP Note 1889081 for more information.
No comments:
Post a Comment